123
FUNCTION SETTING USING SETTINGS
SPECIAL
SPECIAL is the mode for service engineer and only; it is not recommended to be used.
Ref/Krt data
output (STD2)
ON
When DATA OUT button is pressed, internal printing
is done, and REF/KER data are outputted
to the connected PC.
OFF 173
OFF
When DATA OUT button is pressed, internal printing
is done, but REF/KER data are not outputted
to the connected PC.
KR-1W
IP address
Set by ten-key display. IP address of KR-1W is set. NONE 173
KR-1W
Subnet Mask
Set by ten-key display. Subnet mask of KR-1W is set. NONE 173
KR-1W
Default Gateway
Set by ten-key display. Default gateway of KR-1W is set. NONE 173
Image format for
shared folder
transfer
Bitmap The image of a share folder is transfered in Bitmap.
Bitmap 173
JPEG The image of a share folder is transfered in JPEG.
JPEG quality of
shared folder
transfer
Max
The quality of JPEG image transferred is set to
Highest.
Max 174
High The quality of JPEG image transferred is set to High.
Medium
The quality of JPEG image transferred is set to
Medium.
Low The quality of JPEG image transferred is set to Low.
Health check
function
ON
Connection with Viewer is checked to display the
status in the individual screens.
ON 174
OFF No connection check is performed.
Destination of
image to save
KR-1W Viewer
This is set to export the image to Viewer with
IMAGEnet R4 Version 4.14 or later.
Both 174
Folder
The image is exported to the image save folder.
(Equivalent to the conventional function)
Both The image is exported to the two folders above.
Set item display Setting Change button Set contents Initial value Page
To Next Page
