Topcon KR-1W - Page 134

132
FUNCTION SETTING USING SETTINGS SCREEN
SETTING THE ZERNIKE PD
The Zernike PD can be set. Before shipment, the default setting is "Use pupil."
1 Tap the of the set item display "Zernike PD" of "INITIAL."
2 Enter the number by the ten-key display of the .
3 Setting is done by tapping the .
SETTING ZERNIKE DEGREE
Zernike degree can be set. Before shipment, the default setting is "degree 6."
1 Tap the of the set item display "Zernike Degree" of "INITIAL."
2 Enter the number by the ten-key display of the .
3 Setting is complete.
Set Condition button
Setting Change button
OK button
Set Condition button
Setting Change button