145
FUNCTION SETTING USING SETTINGS
SETTING THE PLACID RING DETECTION OVERLAY (PLACID OVERLAY)
When analysis results are initially displayed, Placido Ring Detection Overlay can be set to ON
or OFF. Before shipment, the default setting is "OFF."
1 Tap the of the set item display "Placid Overlay" of "DISPLAY."
2 Tap the and select "ON" or "OFF."
3 Setting is complete.
SETTING THE PUPIL DETECTION OVERLAY (PUPIL OVERLAY)
When analysis results are initially displayed, Pupil Detection Overlay can be set to ON or OFF.
Before shipment, the default setting is "OFF."
1 Tap the of the set item display "Pupil Overlay" of "DISPLAY."
2 Tap the and select "ON" or "OFF."
3 Setting is complete.
SETTING THE ANGLE SCALE OVERLAY
When analysis results are initially displayed, Angle Scale Overlay can be set to ON or OFF.
Before shipment, the default setting is "OFF."
1 Tap the of the set item display "Angle Scale" of "DISPLAY."
2 Tap the and select "ON" or "OFF."
3 Setting is complete.
SETTING TOPO/ABERRATION MAP OVERLAY
This sets whether or not to display (overlay) various maps in the Corneal Aberration map and
IOL Selection map when the analysis results was initially displayed. The default setting is
"OFF". Before shipment, the default setting is " NONE".
• This is not applied except the Corneal Aberration map and IOL Selection map.
1 Tap the of the set item display "Topo/Aberration Map Overlay of
"DISPLAY."
2 Tap and select "NONE," "Axial" or "Instantaneous" of the .
"NONE" : TopoMap overlay is not displayed.
"Axial" : Corneal Axial overlay is displayed.
"Instantaneous" : Corneal Instantaneous overlay is displayed.
"Total ocular aberration" : Total Ocular Aberration overlay is displayed.
"Ocular high-order aberration" : Ocular High-Order Aberration overlay is displayed.
"Corneal high-order aberration" : Corneal High-Order Aberration overlay is displayed.
3 Setting is complete.
Set Condition button
Setting Change button
Set Condition button
Setting Change button
Setting Change button
To Next Page
Loading...
