Topcon KR-1W - Page 153

151
FUNCTION SETTING USING SETTINGS
TYPE OF OPTOTYPES
Type of optotypes is set. The default setting is "Landolt's ring".
1 Tap the of the set item display "Type of optotypes" of "DISPLAY."
2 Tap the and select one of "Landolt" or "Snellen".
3 Setting is complete.
METHOD OF DISPLAYING EYESIGHT VALUE OF SIMULATION
Method of displaying eyesight value of simulation is set. The default setting is "Fraction".
1 Tap the of the set item display "Method of displaying eyesight
value of simulation" of "DISPLAY."
2 Tap the and select either of "Fraction" or "Decimal".
3 Setting is complete.
SETTING OPTOTYPE SIMULATION 1 (UPPER)
The optotype of Simulation 1 (Upper) is set. Before shipment, the default setting is "100 (20/
100)."
1 Tap the of the set item display "Optotype simulation 1 (Upper)" of
"DISPLAY."
2 Enter the number by the ten-key display of the .
3 Setting is done by tapping the .
* Optotype Simulation can be set between 10 and 200 (20/10 - 20/200) with 10 steps.
SETTING OPTOTYPE SIMULATION 2 (MIDDLE)
The optotype of Simulation 2 (Middle) is set. Before shipment, the default setting is "40 (20/
40)."
1 Tap the of the set item display "Optotype simulation 2 (Middle)" of
"DISPLAY."
2 Enter the number by the ten-key display of the .
3 Setting is done by tapping the .
* Optotype Simulation can be set between 10 and 200 (20/10 - 20/200) with 10 steps.
SETTING OPTOTYPE SIMULATION 3 (LOWER)
The optotype of Simulation 3 (Lower) is set. Before shipment, the default setting is "20 (20/
20)."
1 Tap the of the set item display "Optotype simulation 3 (Lower)" of
"DISPLAY."
2 Enter the number by the ten-key display of the .
3 Setting is done by tapping the .
* Optotype Simulation can be set between 10 and 200 (20/10 - 20/200) with 20/10 steps.
Set Condition button
Setting Change button
Set Condition button
Setting Change butto
n
Set Condition button
Setting Change butto
n
OK button
Set Condition button
Setting Change butto
n
OK button
Set Condition button
Setting Change butto
n
OK button