6. SYSTEM MODE EO18-33030
6.5 Self-Test Printing / Dump Mode
6-17
16. Cut Count
It counts the times the cutter cuts.
17. RS232 Protocol
It lists RS-232C settings in the following order: baud rate, data length, parity check, stop bit and flow
control.
18-20. Control Character
The control character your printer is using.
21. Code Page
The character set table.
22. Media
The media type in use.
23. Reprint After Error
When it is enabled, your printer reprints the label after the error fixed if it is printed incorrectly due to the
error.
24. Backfeed Enabled/Disabled
Enable or disable backfeed during the printing process. When it is enabled, your printer moves the paper
forward in a predefined length 1 second after printing, and pulls the paper back in a predefined length
once the printing begins again. When it is disabled, your printer won’t move the paper at all.
25. Cutter Enabled/Disabled
Enable or disable the cutter during the printing process.
26. Peeler Enabled/Disabled
Enable or disable the peeler during the printing process.
27. Cutter/Peeler Offset
Move the cutting line or the peeling position forward or backward. The value in the angle brackets is the
offset unit.
28. IP Address
The static IP address of your printer
The default value is “192.168.10.20.”
29. Subnet Mask
The manually specified subnet mask of your printer
The default value is “255.255.255.0.”
30. Gateway
The manually specified gateway of your printer
The default value is “0.0.0.0.”
31. MAC Address
The unique address assigned to your printer that connects to the internet.
32. DHCP
When DHCP is enabled, it assigns an IP address to your printer automatically.
To Next Page
Loading...
Need help?
General
