Toshiba B-FV4 Series User Manual

2. ELECTRONICS SPECIFICATIONS EO18-33030
2.3 Main PC Board Connector Pin Assignment
2-12
J6 (Feed Gap Sensor (Lower)): This connector is connected to the Feed Gap Sensor (Lower).
J8 (Cutter Module): This connector is connected to the Cutter Module.
J9 (Panel board): This connector is connected to the Panel board.
J11 (Micro Switch): This connector is connected to the Micro Switch.
J13 (Media Sensor): This connector is connected to the Media Sensor.
Signal
Pin
No.
+3.3V 1
ST MEDIA 2
N/C 3
Signal
Pin
No.
+24V 1
GND 2
+3V3 3
GND 4
CUT ON 5
CUT DIR 6
CUT SW 7
+3V3 8
+24V 9
CTYPE 10
GND 11
+24V 12
Signal
Pin
No.
KEY1 1
N/C 2
LED 1 3
LED 2 4
+3V3 5
GND 6
LED 4 7
LED 3 8
GND 9
Signal
Pin
No.
GND 1
COVER SW 2
Signal
Pin
No.
+5V 1
REF I 2
+3V3 3
REF MEDIA 4

Toshiba B-FV4 Series Specifications

General

Resolution	203 dpi
Print Method	Thermal Transfer / Direct Thermal
2D Codes	Data Matrix, PDF417, QR Code, Maxi Code
Operating Temperature	5 – 40 °C
Storage Temperature	-20 – 60 °C
Power Supply	100-240 VAC, 50/60 Hz
Interfaces	USB, Serial (RS-232)
Media Width	25.4 – 112 mm