2. ELECTRONICS SPECIFICATIONS EO18-33030
2.3 Main PC Board Connector Pin Assignment
2-14
P4 (Ethernet port): This connector is used for the Ethernet port (10/100 Base).
P5 (Serial Interface port): This connector is used for the Serial interface (RS-232C).
+5V is output from the pin 1.
The TXD signal is a serial signal and output from the pin 2.
The RXD signal is a serial signal and input into the pin 3.
JP2 (Parallel Interface port): This connector is used for the Parallel interface (Centronics).
Signal
Pin
No.
TD+ 1
TD- 2
RD+ 3
TCT 4
N/C 5
RD- 6
RCT 7
N/C 8
Signal
Pin
No.
+5 V 1
TXD 2
RXD 3
CTS 4
GND 5
RTS 6
N/C 7
RTS 8
N/C 9
Signal
Pin
No.
n/STROBE 1
Data 1-8 2-9
nACK 10
BUSY 11
PE 12
5V 13
NC 14
NC 15
Ground 16
Ground 17
NC 18
Ground 19-30
NC 31
nFAULT 32
NC 33-35
NC 36
To Next Page
Loading...
