System Error Codes
Trunk Programming Error Codes
B-16 Strata CTX Programming - Part 4: Appendices 6/04
308
33
)%
The entered equipment value is invalid.
33
)%
Wrong assignment intervals.
80
)%
The designated trunk equipment does not exist in the system.
309
33
)%
The pause assignment is wrong.
48
)%a
)%
No incoming destination number is entered for the parameter
required.
49
)%
The entered DID conflicts with an existing wild card PCB. The
allowable number of DID assignments including a wild card
PCB is exceeded.
49
)%
The selected GCO conflicts with an existing ILG number.
49
)%
The selected Pool Line Group conflicts with an existing ILG
number.
51
)%
The entered ILG number does not exist in the system.
51
)%
The length of entered DID value exceeds the allowable
contract digit number.
80
)%
The entered GCO key group does not exist in the system.
82
)%
The selected ILG number does not exist in the system. The
number of ILGs exceed the system capacity.
96
)%
)%
The number of allowable GCO or POOL key group
assignments has been exceeded.
98
)%
The allowable number of DID assignments has been
exceeded.
310
33
)%
The entered equipment value is invalid.
48
)%a
)%
No incoming destination number is assigned for the required
parameter.
80
)%
The entered circuit is not set to support the designated trunk.
311 49
)%
Although DISA security is set to Necessary, no DISA code
has been assigned.
312
49
)%
The entered DID number is not assigned to an ILG.
49 The DID Number entered is invalid.
80 DID Number entered does not exist in the system.
82
)%
The entered ILG number does not exist in the system.
313
33
)%
The trunk number entered is out of the range.
33
)%
The entered equipment value is invalid.
49
)%
)%
When Signalling Method field is set to CLASS:
• The Signalling Contents field value must be assigned
• The CLID Equipment Number Position circuit for the CIU
must be entered.
80
)%
The entered trunk number does not exist in the system.
Program Code
Occurred
FB
Sub-
parameter
Error Descriptions
To Next Page
Loading...
