Toshiba Strata CTX28 - Page 479

System Error Codes
Trunk Programming Error Codes
Strata CTX Programming - Part 4: Appendices 6/04 B-17
System Error Codes
315
)%
)%
)%
)%
“NONE” entered in any field is invalid.
33
)%
The entered equipment value is invalid.
49
)%
The PCB installed in the designated Shelf/Slot must be a
RDTU.
316
33
)% The channel group entered is out of the range.
33
)% RPTU Equipment Number entered is invalid.
49
)%
When the equipment is moved, the number of the PCM
highway in the moved equipment is different from the current
equipment.
49
)%
If the Span Interface speed is set to a value not equal to 1.5M,
the Dch position is modified.
52
)%
The entered channel group number conflicts with an existing
ISDN extension(s).
54
)%
The equipment number entered is out of range.
80
)%
The entered channel group number does not exist in the
system.
80
)% The entered circuit must be an assigned ISDN.
317
33
)% The entered equipment value is invalid.
33
)% The ILG entered is out of the range.
33
)% The OLG entered is out of the range.
49
)% “0” was entered in ILG when OLG was not registered.
49
)%
)%
The entered ILG/OLG values do not have ISDN assignments.
49
)% The OLG entered is not registered in the system.
49
)% “0” was entered in OLG when ILG was unregistered.
50
)%
The T-Wait Timer can only be enabled if the Protocol is set to
National ISDN.
52
)%
The entered channel group number conflicts with an existing
ISDN extension(s).
54
)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
The entered channel group number does not exist in the
system.
80
)% The entered circuit must be an assigned ISDN.
80
)% The entered ILG number does not exist in the system.
80
)% The entered OLG number does not exist in the system.
96
)%
The allowable channel group assignments exceed the system
capacity.
Program Code
Occurred
FB
Sub-
parameter
Error Descriptions