Toshiba Strata CTX28 - Page 480

System Error Codes
Trunk Programming Error Codes
B-18 Strata CTX Programming - Part 4: Appendices 6/04
318
33
)% The pause assignment is wrong.
48
)%a
)%
No incoming destination number is assigned for the required
parameter.
49
)% The selected GCO conflicts with an existing ILG number.
49
)%
The selected Pool Line Group conflicts with an existing ILG
number.
80
)% The entered GCO key group does not exist in the system.
82
)% The selected ILG number does not exist in the system.
82
)%
The selected ILG number does not exist in the system. The
number of ILGs exceed the system capacity.
96
)%
)%
The number of allowable GCO or POOL key group
assignments has been exceeded.
319
33
)%a)% The destination number entered is wrong.
48
)%a)% The destination number is not assigned.
320
33
)% The entered equipment value is invalid.
54
)%a)%
The quantity of lines, ISDN channels and PDNs entered
exceeds the number of ports licensed with this processor.
80
)%
The circuit for the designated PCB must be an assigned ISDN
primary trunk.
321
33
)% The OLG entered is out of the range.
80
)% The entered OLG number does not exist in the system.
322
33

The Group CO or Pool Line Group Destination is out of range
(1~128).
80
)% The entered OLG number does not exist in the system.
80
)%
)%
The designated extension number does not exist in the
system.
80
)%
)%
The entered GCO value does not exist in the system.
80
)%
)%
The entered POOL value does not exist in the system.
82
)% The OLG entered is out of the range.
96
)% The allowable system DID assignments has been exceeded.
Program Code
Occurred
FB
Sub-
parameter
Error Descriptions