TP-Link JetStream L2 User Manual

252
Flash Operation
: If selected, the switch will send a Flash Operation
trap when a
flash operation occurs
. The flash operations include firmware
upgrading, system resetting, config restoring and config saving.
VLAN C
reate/Delete If selected, the switch will send a VLAN Create/Delete trap when
a
VLAN is being created or deleted.
IP Change
: If selected, the switch will send an IP Change trap when the
IP
address of the switch is changed.
Storm Control
: If selected, the switch will send a Storm Control
trap when the
broadcast, multicast or UL
rate exceeds the limit. You can
configure the limit on QoS→Bandwidth Control →
Storm
Control page.
Bandwidth Control
: If selected, the switch will send a Bandwidth Control trap when
the
traffic rate of a port exceeds the limit. You can configure the limit
on QoS→Bandwidth Control→Rate limit page.
LLDP:
If selected, the switch will send an LLDP trap when t
he status of
LLDP changes.
MAC Address Table
: If selected, the switch will send a MAC Address Table
trap when
the MAC address table has any changes.
Loopback Detection:
If selected, the switch will send a Loopback Detection
trap when
the status of loopback detection changes.
Spanning Tree
: If selected, the switch will send a Spanning Tree trap when t
he
status of STP on the port changes.
Port Access
: If selected, the switch will send a Port Access
trap when some
users try to log on to the web management page
via ports
that have no authority. You can configure the access control pol
icy
on System→Access Security→Access Control page.
IP
-MAC Binding: If selected, the switch will send an IP-MAC Binding
trap when it
receives a packet from the host that does not match the rules in
IP-MAC binding table. You can configure the IP-MAC Binding
policy on Network Security→IP-MAC Binding page.
IP Duplicate
: If selected, the switch will send an IP Duplicate trap when
another
host uses the switch's IP address.
DHCP Filter
: If selected, the switch will send a DHCP Filter
trap when it
receives a DHCP packet from an untrusted port.
D
DM Temperature: If selected, the switch will send a DDM Temperature trap when t
he
value of DDM temperature exceeds the threshold.
DDM Voltage:
If selected, the switch will send a DDM Voltage trap when t
he
value of DDM voltage exceeds the threshold.
DDM
Bias Current: If selected, the switch will send a DDM Bias Current trap when t
he
value of DDM bias current exceeds the threshold.
DDM Tx Power:
If selected, the switch will send a DDM Tx Power trap when t
he
value of DDM Tx power exceeds the threshold.

TP-Link JetStream L2 Specifications

General

Brand	TP-Link
Model	JetStream L2
Category	Switch
Language	English