Valleylab CUSA EXcel-8 - Page 120

User Troubleshooting
Condition Causes Recommended Action
Little or no vibration or fragmentation Tip loose due to improper assembly 1. Press the Status button to place the
(Amplitude LEDs may illuminate well system in Standby mode.
below setpoint)—continued 2. Press the Test button to test the
handpiece and tip.
3. Ifthe Vibration alert activates, do one
of the following:
If tip assembled in a nonsterile area:
a. Remove the handpiece from the
Sterile field.
b. Use the tip torquing base and
wrench to tighten the tip.
c. Test the tip.
4. Sterilize the handpiece.
If sterile tip assembled to handpiece on the
sterile field:
a. Use the sterilizable torque base
and a disposable sterile wrench to
tighten the tip. (Refer to the
Supplement, Assembling or
Changing Tips on the Sterile Field,
which is part 2 of the CUSA EXcel
System User's Guide.)
b. Test the tip.
funooussajqnoil
CUSA EXcel-8 System Service Manual 10-11
Ec