Xerox WorkCentre 3550 - Page 88

Printing using Windows
Xerox WorkCentre 3550
User Guide
88
2. Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an
installation window appears.
• If the installation window does not appear,
click Start and then Run. Type X:\Setup.exe,
replacing “X” with the letter which represents
your drive and click OK.
• If you use Windows Vista, click Start > All
programs > Accessories > Run, and type
X:\Setup.exe. If the AutoPlay window appears
in Windows Vista, click Run Setup.exe in Install
or run program field, and click Continue in the User Account Control window.
3. Click Install Software.
4. Click Typical installation for a network printer and
follow the wizard instruction to select and install the
printer.
Note: For Custom install instructions, refer to the
System Administrator Guide.
5. After the installation is finished, click Finish.
If the Test Print operation is successful, continue on to
the next setup procedure in this document. If the print
operation failed, refer to Troubleshooting on page 161.