06/2014
9-11
WC 5022/5024
9.1.6 Stand
Installation/Removal
Version 1.0
Figure 5 j0xh91023
11. Push in Tray 2 of the One Tray Module.
12. Remove the Rear Cover of the Stand. (Figure 6)
a. Loosen the screw.
b. Slide the Foot Cover.
c. Remove the screw (x4).
d. Remove the Rear Cover.
Figure 6 j0lj91136
13. Install the Joint. (Figure 7)
a. Hang the hook of the Joint to the One Tray Module.
b. Secure the Joint by using the screw.
Figure 7 j0lj91137
14. Reinstall the parts removed in Procedure 12.
WARNING
As the IOT is very heavy, make sure you have 3 or more persons (2 at the left and 1
at the right) to perform the mounting.
15. Hold onto the IOT at the indicated positions (A: x4) and align it to the positioning pin (x2)
of the One Tray Module to mount it.
(Figure 8)
Figure 8 j0lj91125
To Next Page
Loading...
