YASKAWA L1000A - Page 250

5.10 o: Operator Related Settings
250 YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual
■ o1-04: V/f Pattern Setting Units
Determines the units used for the frequency reference when setting parameters that create the V/f pattern: E1-04, E1-06,
E1-09, E1-11, and E2-04. For motor 2, this includes parameters E3-04, E3-06, E3-07, E3-09, and E4-04.
Enabled only in vector control modes (CLV and CLV/PM).
Setting 0: Hz
Setting 1: r/min
Note: For motor 2, o1-04 can only be set to 0 for Hertz.
■ o1-05: LCD Contrast Control
Sets the brightness of the LCD operator (option). Lower the setting to make the LCD brighter or raise the setting to make
the LCD darker.
■
o1-06: User Monitor Selection Mode
Note: Available in drive software PRG: 7017 or later.
The digital operator display monitors shown directly below the active monitor are the next two sequential monitors. If
o1-06 (User Monitor Selection Mode) is set to “1: 3 Monitor Selectable”, those two monitors are locked as specified by
parameters o1-07 and o1-08 and will not change as the top parameter is scrolled with the Up/Down Arrow keys.
Setting 0: 3 Monitor Sequential (Displays the next 2 sequential monitors)
Setting 1: 3 Monitor Selectable (o1-07, and o1-08 selected monitor is displayed)
■ o1-07: Second Line Monitor Selection
Note: Available in drive software PRG: 7017 or later.
For example, set “104” to display monitor parameter U1-04.
Selects the monitor displayed on the second line. The monitor parameter number is entered into the spaces provided:
U-.
Some monitors are only available in certain control modes.
■
o1-08: Third Line Monitor Selection
Note: Available in drive software PRG: 7017 or later.
For example, set “104” to display monitor parameter U1-04.
Selects the monitor displayed on the third line. The monitor parameter number is entered into the spaces provided:
U-.
Some monitors are only available in certain control modes.
No. Parameter Name Setting Range Default
o1-04 V/f Pattern Setting Units 0 or 1 Determined by A1-02
No.
<1> Available in drive software versions PRG: 7200 or later.
Parameter Name Setting Range Default
o1-05 <1> LCD Contrast Control 0 to 5 3
No. Parameter Name Setting Range Default
o1-06 User Monitor Selection Mode 0, 1 0
No. Parameter Name Setting Range Default
o1-07 Second Line Monitor Selection
101 to 699
U1-01 (Speed Reference) to
U6-99 (Option Monitor 20)
102
No. Parameter Name Setting Range Default
o1-08 Third Line Monitor Selection
101 to 699
U1-01 (Speed Reference) to
U6-99 (Option Monitor 20)
103
SIEP_C710616_38F_5_0.book 250 ページ ２０１５年１１月９日 月曜日 午後３時３６分