EasyManua.ls Logo

YASKAWA L1000A - Page 265

YASKAWA L1000A
522 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5.11 S: Elevator Parameters
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual 265
Parameter Details
5
S4-02: Light Load Direction Search Method
Determines the method used to perform Light Load Direction Search.
Setting 0: Output current
Setting 1: Detect direction of regeneration
S4-03: Light Load Direction Search Time
Sets the time to perform Light Load Direction Search.
S4-04: Light Load Direction Search Speed Reference
Sets the speed reference to use during Light Load Direction Search.
S4-05: Rescue Operation Torque Limit
Sets the torque limit used during Rescue Operation.
S4-06: Rescue Operation Power Supply Selection
Specifies the type of backup power supply the drive should switch to when the power goes out.
Setting 0: Battery
Setting 1: UPS (single-phase)
Setting 2: UPS (three-phase)
S4-07: UPS Power
Sets the capacity of the UPS.
S4-08: UPS Operation Speed Limit Selection
Determines how a speed limit should be applied to the Rescue Operation speed (S4-15) when operating from a UPS. The
drive calculates the appropriate speed limit based on the UPS capacity set in S4-07. This speed limit helps prevent voltage
saturation and motor stall during Rescue Operation.
Setting 0: Disabled
Setting 1: Enabled until Light Load Direction Search is complete
Setting 2: Enabled until stop
No. Parameter Name Setting Range Default
S4-02 Light Load Direction Search Method 0 or 1 1
No. Parameter Name Setting Range Default
S4-03 Light Load Direction Search Time 0.0 to 5.0 s 1.0 s
No. Parameter Name Setting Range Default
S4-04 Light Load Direction Search Speed Reference 0.00 to 20.00% Determined by A-02
No. Parameter Name Setting Range Default
S4-05 Rescue Operation Torque Limit 0 to 300% 100%
No. Parameter Name Setting Range Default
S4-06 Rescue Operation Power Supply Selection 0 to 2 0
No. Parameter Name Setting Range Default
S4-07 UPS Power 0.0 to 100.0 kVA 0.0 kVA
No. Parameter Name Setting Range Default
S4-08 UPS Operation Speed Limit Selection 0 to 2 2
SIEP_C710616_38F_5_0.book 265 ージ 015年11月9日 月曜日 午後3時36分

Table of Contents

Other manuals for YASKAWA L1000A

Related product manuals