YASKAWA L1000A - Page 365

8.4 Option Card Installation
YASKAWA ELECTRIC SIEP C710616 38F YASKAWA AC Drive - L1000A Technical Manual 365
Peripheral Devices & Options
8
Crimp Terminals
Yaskawa recommends using CRIMPFOX 6 by Phoenix Contact or equivalent crimp terminals with the specifications
listed in Table 8.11 for wiring to ensure proper connections.
Note: Properly trim wire ends so loose wire ends do not extend from the crimp terminals.
Table 8.11 Crimp Terminal Sizes
6. Route the option wiring.
Depending on the drive model, some drives may require routing the wiring through the side of the front cover to
the outside. For drive models CIMR-LU20008 through 20033, 40005 through 40018, and 50003
through 50010, cut out the perforated openings on the left side of the drive front cover as shown in
Figure 8.14-A and leave no sharp edges to damage wiring.
Route the wiring inside the enclosure as shown in Figure 8.14-B for drive models CIMR-LU20047 through
20415, 40024 through 40605, and 50013 through 50200 that do not require routing through the front
cover.
Figure 8.12
Figure 8.14 Wire Routing Examples
Wire Gauge
mm
2
Phoenix Contact Model
L
mm (in)
d1
mm (in)
d2
mm (in)
0.25 (24 AWG)
AI 0.25 - 6YE
AI 0.25 - 6BU
10.5 (13/32) 0.8 (1/32) 2 (5/64)
0.34 (22 AWG) AI 0.34 - 6TQ 10.5 (13/32) 0.8 (1/32) 2 (5/64)
0.5 (20 AWG) AI 0.5 - 6WH 12 (15/32) 1.1 (3/64) 2.5 (3/32)
A – Route wires through the openings
provided on the left side of the
front cover.
<1>
(CIMR-LU20008 through 20033,
40005 through 40018, and
50003 through 50010)
<1> The drive will not meet IP20/NEMA 1, UL Type 1 requirements if wiring is exposed outside the
enclosure.
B – Use the open space provided
inside the drive to route option
wiring.
(CIMR-LU20047 through 20415,
40024 through 40605, and
50013 through 50200)
d1
d2
6 mm
(0.24 in.)
L
B
A
SIEP_C710616_38F_5_0.book 365 ページ ２０１５年１１月９日 月曜日 午後３時３６分