Yealink SIP-T58V/A - Page 303

Configuring Advanced Features
281
(Configuration File)
g
waiting tone.
Parameters:
call_waiting.enable
call_waiting.tone
call_waiting.on_code
call_waiting.off_code
Web User Interface
Configure call waiting.
Navigate to:
http://<phoneIPAddress>/servlet?m
=mod_data&p=features-general&q
=load
Configure call waiting tone.
Navigate to:
http://<phoneIPAddress>/servlet?m
=mod_data&p=features-audio&q=l
oad
Phone User Interface
Configure call waiting and call
waiting tone.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
call_waiting.enable
0 or 1
1
Description:
Enables or disables call waiting feature.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), a new incoming call is automatically rejected by the IP phone
with a busy signal (configured by the parameter “features.normal_refuse_code”) while
during a call.
If it is set to 1 (Enabled), the touch screen will present a new incoming call while during a
call.
In both cases, users can put an active call on hold to make outgoing calls.
Web User Interface:
Features->General Information->Call Waiting
Phone User Interface:
Settings->Features->Call Waiting->Call Waiting