Yealink SIP-T58V/A

Setting Up Your System
21
To configure DHCP via web user interface:
1. Click on Network->Basic.
2. In the IPv4 Config block, mark the DHCP radio box.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
4. Click OK to reboot the phone.
To configure DHCP via phone user interface:
1. Tap Settings->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Tap the Type field.
3. Tap DHCP in the pop-up dialog box.
4. Tap to accept the change.
The phone prompts you to reboot the phone.
5. Tap OK to reboot the phone.
The settings will take effect after a reboot.
Static DNS
Static DNS address(es) can be configured and used even though DHCP is enabled.
Procedure
Static DNS can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.c
fg
Configure the static DNS feature.
Parameter:
static.network.static_dns_enable
<MAC>.cfg
Configure static DNS address.