Configuring Advanced Features
507
Web User Interface:
Directory->Multicast IP->Paging Priority Active
Phone User Interface:
None
multicast.receive_priority.priority
Description:
Configures the priority of the voice/video call (a normal phone call rather than a multicast
paging call) in progress.
1 is the highest priority, 31 is the lowest priority.
0-Disabled
1-1
2-2
3-3
…
31-31
If it is set to 0 (Disabled), all incoming multicast paging calls will be automatically ignored
when a voice/video call is in progress.
If it is not set to 0 (Disabled), the IP phone will receive the incoming multicast paging call
with a higher or same priority than this value and ignore that with a lower priority than this
value when a voice/video call is in progress.
Web User Interface:
Directory->Multicast IP->Paging Barge
Phone User Interface:
None
To configure multicast listening addresses via web user interface:
1. Click on Directory->Multicast IP.
2. Select the desired value from the pull-down list of Paging Barge.
3. Select the desired value from the pull-down list of Paging Priority Active.
4. Enter the multicast IP address(es) and port number (e.g., 224.5.6.20:10008) which the phone
listens to for incoming RTP multicast in the Listening Address field.
1 is the highest priority and 31 is the lowest priority.
5. Enter the label in the Label field.
Label will appear on the touch screen when receiving the multicast RTP stream.
To Next Page
Loading...
Need help?
General
