Administrator’s Guide for SIP-T5 Series Smart Media Phones
506
If it is set to 0, the current volume of the speaker takes effect. The volume of the speaker
can be adjusted by pressing the Volume key in advance when the phone is during a call.
You can also adjust the volume of the speaker during the paging call.
If it is set to 1 to 15, the configured volume takes effect and the current volume of the
speaker will be ignored. You are not allowed to adjust the volume of the speaker during
the paging call.
Example:
multicast.listen_address.1.volume = 1
Web User Interface:
None
Phone User Interface:
None
multicast.receive.use_speaker
Description:
Enables or disables the IP phone to always use the speaker as the audio device when
receiving the multicast paging calls.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the engaged audio device will be used when receiving the
multicast paging calls.
Web User Interface:
None
Phone User Interface:
None
multicast.receive_priority.enable
Description:
Enables or disables the IP phone to handle the incoming multicast paging calls when there
is an active multicast paging call on the IP phone.
0-Disabled
1-Enabled
If it is set to 0 (Disabled), the IP phone will ignore the incoming multicast paging calls when
there is an active multicast paging call on the IP phone.
If it is set to 1 (Enabled), the IP phone will receive the incoming multicast paging call with a
higher or equal priority and ignore that with a lower priority.
To Next Page
Loading...
Need help?
General
