Yealink SIP-T58V/A

Configuring Advanced Features
505
Parameters
Permitted Values
Default
None
multicast.listen_address.X.label
(X ranges from 1 to 31)
String within 99
characters
Blank
Description:
(Optional.) Configures the label to be displayed on the touch screen when receiving the
multicast paging calls.
Example:
multicast.listen_address.1.label = Paging1
Web User Interface:
Directory->Multicast IP->Multicast Listening->Label
Phone User Interface:
None
multicast.listen_address.X.channel
(X ranges from 1 to 31)
Integer from 0 to 30
0
Description:
Configures the channel that the IP phone listens to.
If it is set to 0, the IP phone can receive an RTP stream of the pre-configured multicast
address from the IP phones running old firmware version (old paging mechanism), from
the IP phones listen to the channel 0, or from the available third-party devices (e.g., Cisco
IP phones).
If it is set to 1 to 25, the IP phone can receive an RTP stream of the pre-configured
multicast address on the channel 1 to 25 respectively from Yealink or Polycom IP phones.
It it is set to 26 to 30, the IP phone can receive the RTP stream of the pre-configured
multicast address on the channel 26 to 30 respectively from Yealink IP phones.
Example:
multicast.listen_address.1.channel = 2
Web User Interface:
Directory->Multicast IP->Multicast Listening->Channel
Phone User Interface:
None
multicast.listen_address.X.volume
(X ranges from 1 to 31)
Integer from 0 to 15
0
Description:
Configures the volume of the speaker when receiving the multicast paging calls.