Setting Up Your System
33
3. Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS fields.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click OK to reboot the phone.
To configure the IP address mode via phone user interface:
1. Tap Settings->Advanced (default password: admin) ->Network->WAN Port.
2. Tap the Type field.
3. Tap IPv4 or IPv4 and IPv6 in the pop-up dialog box.
4. Tap to accept the change.
The phone prompts you to reboot the phone.
5. Tap OK to reboot the phone.
The settings will take effect after a reboot.
To configure a static IPv4 address via phone user interface:
1. Tap Settings->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Tap the Type field.
3. Tap Static IP in the pop-up dialog box.
4. Enter the desired value in the IP, Subnet Mask, Default Gateway, Primary DNS and
Secondary DNS field respectively.
5. Tap to accept the change.
The phone prompts you to reboot the phone.
6. Tap OK to reboot the phone.
The settings will take effect after a reboot.
To Next Page
Loading...
Need help?
General
