Setting Up Your System
39
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps
Note: You can set the transmission speed to 1000Mbps/Auto Negotiate to transmit in
1000Mbps if the IP phone is connected to the switch supports Gigabit Ethernet. We
recommend that you do not change this parameter. If you change this parameter, the IP
phone will reboot to make the change take effect.
Web User Interface:
Network->Advanced->Port Link->WAN Port Link
Phone User Interface:
None
static.network.pc_port.speed_duplex
Description:
Configures the transmission method of the PC port.
0-Auto Negotiate
1-Full Duplex 10Mbps
2-Full Duplex 100Mbps
3-Half Duplex 10Mbps
4-Half Duplex 100Mbps
5-Full Duplex 1000Mbps
Note: It works only if the value of the parameter “static.network.pc_port.enable” is set to 1
(Auto Negotiate). You can set the transmission speed to 1000Mbps/Auto Negotiate to
transmit in 1000Mbps if the IP phone is connected to the switch supports Gigabit Ethernet.
We recommend that you do not change this parameter. If you change this parameter, the IP
phone will reboot to make the change take effect.
Web User Interface:
Network->Advanced->Port Link->PC Port Link
Phone User Interface:
None
To configure the transmission methods of Ethernet ports via web user interface:
1. Click on Network->Advanced.
2. Select the desired value from the pull-down list of WAN Port Link.
To Next Page
Loading...
Need help?
General
