Yealink SIP-T58V/A

Administrator’s Guide for SIP-T5 Series Smart Media Phones
614
Parameters
Permitted Values
Default
When audio codec is Opus, the default value is 0;
When audio codec is G726-40, the default value is 0;
When audio codec is G726-32, the default value is 0;
When audio codec is G726-24, the default value is 0;
When audio codec is G726-16, the default value is 0;
When audio codec is iLBC, the default value is 0;
When audio codec is G723_63, the default value is 0;
When audio codec is G723_53, the default value is 0;
Example:
account.1.codec.g722_1c_48kpbs.enable = 1
account.1.codec.g722_1c_32kpbs.enable = 1
account.1.codec.g722_1c_24kpbs.enable = 1
account.1.codec.g722_1_24kpbs.enable = 1
account.1.codec.g722.enable = 1
account.1.codec.pcmu.enable = 1
account.1.codec.pcma.enable = 1
account.1.codec.g729.enable = 1
account.1.codec.opus.enable = 0
account.1.codec.g726_40.enable = 0
account.1.codec.g726_32.enable = 0
account.1.codec.g726_24.enable = 0
account.1.codec.g726_16.enable = 0
account.1.codec.ilbc.enable = 0
account.1.codec.g723_63.enable = 0
account.1.codec.g723_53.enable = 0
It means that the codecs G.722.1c(48kb/s), G.722.1c(32kb/s), G.722.1c(24kb/s),
G.722.1(24kb/s), G722, PCMU, PCMA and G729 are enabled on the account 1.
Note: The name of audio codec in this parameter should be the correct one as listed in
the above example, otherwise the corresponding configuration will not take effect.
Web User Interface:
Account->Codec->Audio Codec
Phone User Interface:
None
account.X.codec.<payload_type>.priority
(where <payload_type> should be replaced by
Integer from 0 to
8
Refer to the
following