Yealink SIP-T58V/A

Troubleshooting
717
Internet port to the PC port.
Procedure
Span to PC port can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.cf
g
Configure span to PC port.
Parameter:
static.network.span_to_pc_port
Web User Interface
Configure span to PC port.
Navigate to:
http://<phoneIPAddress>/servlet?m=m
od_data&p=network-adv&q=load
Details of the Configuration Parameter:
Parameter
Permitted Values
Default
static.network.span_to_pc_port
0 or 1
0
Description:
Enables or disables the IP phone to span data packets received from the Internet port to the
PC port.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), all data packets from Internet port can be received by PC port.
Note: It works only if the value of the parameter “static.network.pc_port.enable” is set to 1
(Auto Negotiate). If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Advanced->Span to PC->Span to PC Port
Phone User Interface:
None
To enable span to PC port via web user interface:
1. Click on Network->Advanced.