Yealink SIP-T58V/A

Setting Up Your System
53
Parameters
Permitted Values
Default
Web User Interface:
Network->Advanced->CDP->Active
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->CDP->CDP Status
static.network.cdp.packet_interval
Integer from 1 to
3600
60
Description:
Configures the interval (in seconds) for the IP phone to send the CDP (Cisco Discovery
Protocol) request.
Note: It works only if the value of the parameter “static.network.cdp.enable” is set to 1
(Enabled). If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->CDP->Packet Interval (1~3600s)
Phone User Interface:
Settings->Advanced (default password: admin) ->Network->CDP->Packet Interval
To configure CDP via web user interface:
1. Click on Network->Advanced.
2. In the CDP block, select the desired value from the pull-down list of Active.
3. Enter the desired time interval in the Packet Interval (1~3600s) field.
4. Click Confirm to accept the change.