To Next Page

To Previous Page

Administrator’s Guide for SIP-T5 Series Smart Media Phones

A dialog box pops up to prompt that settings will take effect after a reboot.

5. Click OK to reboot the phone.

To configure CDP feature via phone user interface:

1. Tap Settings->Advanced (default password: admin) ->Network->CDP->CDP Status.

2. Tap the On radio box in the CDP Status field.

3. Enter the priority value (1-3600s) in the Packet Interval field.

4. Tap to accept the change.

The phone prompts you to reboot the phone.

5. Tap OK to reboot the phone.

The settings will take effect after a reboot.

Manual Configuration for VLAN in the Wired Network

VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port and PC

port manually. Before configuring VLAN on the IP phone, you need to obtain the VLAN ID from

your network administrator.

Procedure

VLAN can be configured using the following methods.

Central

Provisioning

(Configuration File)

<y0000000000xx>.cfg

Configure VLAN for the Internet port

and PC port manually.

Parameters:

static.network.vlan.internet_port_enabl

static.network.vlan.internet_port_vid

static.network.vlan.internet_port_priori

static.network.vlan.pc_port_enable

static.network.vlan.pc_port_vid

static.network.vlan.pc_port_priority

Web User Interface

Configure VLAN for the Internet port

and PC port manually.

Navigate to:

http://<phoneIPAddress>/servlet?m=

mod_data&p=network-adv&q=load

Phone User Interface

Configure VLAN for the Internet port

and PC port manually.

Yealink SIP-T58V/A User Manual

Questions and Answers: