Setting Up Your System
77
Description:
Configures the maximum TCP port.
Note: The value of the maximum TCP port cannot be less than that of the minimum TCP
port (configured by the parameter “sip.min_tcp_port”). If you change this parameter, the
IP phone will reboot to make the change take effect.
Web User Interface:
Network->Advanced->TCP Port Scope
Phone User Interface:
None
To configure reserved ports via web user interface:
1. Click on Network->Advanced.
2. Enter the desired UDP port scope in the UDP Port Scope field.
3. Enter the desired TCP port scope in the TCP Port Scope field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
5. Click OK to reboot the phone.
To Next Page
Loading...
