ABB ACS880 - Page 581

What to doCause
Event name /
Aux. code
Code
(hex)
Contact your local ABB representative.(Asynchronous motors only)
Acceleration did not finish within
reasonable time.
0009
Contact your local ABB representative.(Asynchronous motors only)
Deceleration did not finish within
reasonable time.
000A
Contact your local ABB representative.(Asynchronous motors only) Speed
dropped to zero during ID run.
000B
Contact your local ABB representative.(Permanent magnet motors only) First
acceleration did not finish within
reasonable time.
000C
Contact your local ABB representative.(Permanent magnet motors only)
Second acceleration did not finish
within reasonable time.
000D
Contact your local ABB representative.Internal error.000E…0010
Try to perform ID run again.(SynRM only) Rotor orientation not
correct during the pulse test.
0011
Contact your local ABB representative.
Check that nominal power is as
advised in Advanced Standstill ID run
description.
Not possible to perform Advanced
Standstill ID run.
0012
Contact your local ABB representative.
Check name plate data.(Asynchronous motors only) Error in
motor data.
0013
Contact your local ABB representative.
Contact your local ABB representative.Acceleration did not finish within
reasonable time during Autophasing
ID run.
0014
Contact your local ABB representative.Advanced standstill failure.0015
Check the auxiliary code. Add 2 to the
code to find out the node address of the
faulted drive.
A follower drive has tripped.FollowerFF7E
Correct the fault in the follower drive.
Check the fault information provided by
the PLC.
A fault trip command has been received
through fieldbus adapter A.
FB A force tripFF81
Check the fault information provided by
the PLC.
A fault trip command has been received
through fieldbus adapter B.
FB B force tripFF82
Check the fault information provided by
the Modbus controller.
A fault trip command has been received
through the embedded fieldbus interface.
EFB force tripFF8E
Fault tracing 581