KNX control elements and application parameters
Control element: "Dimmer slider"
Product manual 2CKA00xx73xxxxx
126
10.4.8 Slider sends
Options: When releasing the slider
Cyclic
The parameter is used to specify whether the signal is sent "When releasing the slider" or
"Cyclic".
– When releasing the slider: No additional parameters available.
– Cyclic: The following supplementary parameter is available:
Telegram is repeated every [sec.]:
Options: Setting option from 0.25 - 1.25 seconds
The parameter is used to specify the space of time between two dimming telegrams.
10.4.9 Brightness change [%]
Options: Setting option from 1 - 20
The parameter is used to set the number of steps (in percent) for dimming. The brightness
change takes place when the slider is released.
10.4.10 Enable 1-bit communication object "Disable"
Options: Deactivated
Activated
There is the option of temporarily disabling the function via an additional communication object
"Disable".
To Next Page
Loading...
