KNX control elements and application parameters
"Switch" control element
Product manual 2CKA00xx73xxxxx
110
– 14-byte text: Makes it possible to send any text. The following supplementary parameter is
available:
Sent value 1 / value 2 [max- 14 characters]:
Options: <Text>
The length of the text is limited to 14 characters.
10.1.5 Status control element (icon/text) is operated via a separate object
Options: No
Yes
An additional 1-bit communication object "Status" is enabled via the parameter.
When the object has been enabled, the status display of the control element indicates the
current status of the object. The feedback object can ensure that the correct status is always
displayed.
If an actuator has a separate feedback object, this additional object can check whether the
actuator has switched. For this the feedback object of the actuator must be connected with the
feedback object of the button via a common group address (Action).
If the status display is not activated via a feedback object, the control element always changes
to the other status when actuated.
10.1.6 Icon type
Options: Icons
Text
The parameter is used to set whether an icon or a text is displayed.
– Icons:
Icons for On:
Options: <Selection of an icon from the list>
The selected icon is displayed when the light is switched on.
Icons for Off:
Options: <Selection of an icon from the list>
The selected icon is displayed when the light is switched off.
– Text:
Text for On:
Options: <Text>
The entered text is displayed when the light is switched on.
To Next Page
Loading...
Need help?
General
