Initial commissioning of device
Product manual 2CKA00xx73xxxxx
43
7.1 Initial commissioning with ABB-free@home
®
The steps described in the following refer to initial commissioning with ABB-free@home
®
or
ABB-free@home
®
+ ABB-Welcome
®
are made directly in ABB SmartTouch
®
. Ensure that the
steps from have already been carried out.
1. For the configuration with ABB-free@home
®
, select the option "free@home“ or "free@home
+ Welcome“.
2. Then connect the panel with the corresponding System Access Point.
– For this, select the correct System Access Point from the list. Please note that the
process can take up to 5 minutes.
Fig. 19: Connecting the panel with the System Access Point
Notice
If there is more than one System Access Point in a free@home system, the
System Access Point to which a connection is to be established must be
selected manually.
3. Change to the web-based surface of the System Access Point.
To Next Page
Loading...
