KNX control elements and application parameters
"Blind" control element
Product manual 2CKA00xx73xxxxx
132
The parameter is used to set how long the button must be pressed to recognize a long
operation.
– Short = move/stop, long = stepwise: A short press of the button triggers a move command.
A long press of the button triggers a command to adjust the slats or a stop command. The
following supplementary parameter is available:
Long operation after ...:
Options: Setting option from 0.3 - 10 seconds
The parameter is used to set how long the button must be pressed to recognize a long
operation.
Repeat of all "Stepwise/stop" telegrams:
Options: Setting option from 0.3 - 10 seconds
The parameter is used to set the space of time between two "Stepwise/stop" telegrams.
– Short = move/stop: At each short actuation the following commands are sent consecutively
to linked blind actuators:
■
Move command
■
Stop command
■
Move command
■
Stop command
■
etc.
10.6.5 Icon type
Options: Blind animation
Shutter animation
Marquee animation
Hang animation
User-defined
The parameter is used to set whether a standard icon or a self-selected icon ("user-defined") is
displayed.
The following supplementary parameters are available for all options:
Position for up/open icon:
Options: Left
Right
The parameter is used to specify whether the icon for "Up/Open" is positioned on the right or left
side of the control element.
Icon for up/open:
Options: <Selection of an icon from the list>
The parameter is used to select the icon that is to be displayed in the control element for
"Up/Open".
To Next Page
Loading...
