Commissioning of the KNX Function via DCA (from ETS5)
Product manual 2CKA00xx73xxxxx
47
8.1.2 Installation of the Busch-SmartTouch
®
ETS Touch DCA App
For the assembly of the control elements, the initial commissioning of the ABB SmartTouch
®
and for the display of the DCA commissioning tool, a special app must be installed.
This app can then be called up in the ETS via an additional tab (DCA). For this a licensed
version of the ETS Professional Software must be installed on the target computer for the
installation. At least the latest version of the ETS5 is required.
Notice
■
Also ETS6 can be used.
■
The ETS app can be downloaded via the electronic catalogue (www.busch-
jaeger-catalogue.com).
■
The ETS app can also be downloaded directly via the homepage of the KNX
organisation (https://knx.org).
■
The apps are called up as follows:
– Up to including ETS5: on the ETS start page via "App" (bottom right).
– From ETS6: via the ETS settings.
To Next Page
Loading...
