KNX control elements and application parameters
Application "Fault and alarm messages" - Global settings
Product manual 2CKA00xx73xxxxx
187
10.18 Application "Fault and alarm messages" - Global settings
10.18.1 Use of fault and alarm messages
Options: Deactivated
Activated
The parameter is used to specify whether the fault and alarm messages are displayed.
– Disabled: No display in the panel. No additional parameters available.
– Activated: The following parameters appear:
10.18.2 Page PIN-protected
Options: Deactivated
Activated
The parameter is used to specify whether the fault and alarm messages application page is
protected by a PIN code.
– Deactivated: The application page is not protected.
– Activated: The application page can only be called up by entering a PIN code. The following
supplementary parameter is available:
PIN code level:
Options: Level 1
Level 2
Level 3
Level 4
Level 5
The parameter is used to specify the PIN code level for the application page.
Notice
Details about the PIN code, see chapter 8.6.1 “Basic settings (system
settings) of the panel“ on page 56.
To Next Page
Loading...
