KNX control elements and application parameters
Control element "RTC control element"
Product manual 2CKA00xx73xxxxx
138
10.7.9 Heating/cooling switchover
Options: Deactivated
Activated
The parameter is used to specify whether the RTC control element can be switched over
between heating and cooling mode.
10.7.10 Fan coil control during heating mode
Options: Deactivated
Activated
The parameter is used to specify whether the fan coil fan is activated during heating mode.
10.7.11 Fan coil control during cooling mode
Options: Deactivated
Activated
The parameter is used to specify whether the fan coil fan is activated during cooling mode.
10.7.12 Setting the temperature unit via object
Options: No
Yes
The parameter is used to specify whether it is possible to set the temperature unit via a
communication object.
10.7.13 Enable 1-bit communication object "Disable"
Options: Deactivated
Activated
There is the option of temporarily disabling the function via an additional communication object
"Disable".
To Next Page
Loading...
