KNX control elements and application parameters
Application "Time programs"
Product manual 2CKA00xx73xxxxx
199
10.22 Application "Time programs"
10.22.1 Page PIN-protected
Options: No
Yes
The parameter is used to specify whether the time programs application page is protected by a
PIN code.
– No: The application page is not protected.
– Yes: The application page can only be called up by entering a PIN code. The following
supplementary parameter is available:
PIN code level:
Options: Level 1
Level 2
Level 3
Level 4
Level 5
The parameter is used to specify the PIN code level for the application page.
Notice
Details about the PIN code, see chapter 8.6.1 “Basic settings (system
settings) of the panel“ on page 56.
10.22.2 Overwriting time programs during download
Options: No
Yes
The parameter is used to specify whether the existing time programs are to be overwritten
during the download.
– No: The existing time programs are not to be overwritten during the download.
– Yes: The existing time programs will be overwritten during the download.
To Next Page
Loading...
Need help?
General
