KNX control elements and application parameters
Application "Internal RTC"
Product manual 2CKA00xx73xxxxx
220
10.24.23 Setpoint settings — Setpoint temperature for heating comfort (°C)
Options: Setting option between 10 - 40
Specifies the comfort temperature for heating when people are present.
Note
This parameter is only available when the "Control function" parameter is set on
"Heating, "Heating with additional stage", "Heating and cooling" or "Heating and
cooling with additional stage" and parameter "Setpoint heating comfort =
setpoint cooling comfort" is set on "No".
10.24.24 Setpoint settings — Reduction for standby heating (°C)
Options: Setting option between 10 - 40
Specifies the temperature in heating mode when nobody is present. On devices with a display,
this mode is indicated by the standby icon.
Note
This parameter is only available when the "Control function" parameter is set on
"Heating", "Heating with additional stage", "Heating and cooling" or "Heating and
cooling with additional stages".
10.24.25 Setpoint settings — Reduction for ECO heating (°C)
Options: Setting option between 0 - 15
Specifies the temperature in heating mode when nobody is present. On devices with a display,
this mode is indicated by the eco icon.
To Next Page
Loading...
Need help?
General
