Function Off Select the colour and the state for every indicator if the selected function is
OFF.
Change
function
Click this button to change the function for this indicator. The function can
be enabled or used for a system, area, zone or keyswitch.
LED Always Select if LED indicators should be active when the keys are deactivated.
Audible Indications
Alarms Select if the alarms should be audible.
Entry/Exit Select if entry/exit should be audible.
Key press Select if keypress should be audible.
Deactivation
Calendar Select if indicator expander should be limited by calendar.
Mapping
gate
Select if indicator module should be limited by a mapping gate.
Keyswitch Select if indication module should be limited by a keyswitch.
Keypad Select if indicator module should be limited to a valid PIN entered on a
keypad. (see warning above)
Card reader Select if indicator module should not be activated until a valid card/fob is
presented to the built-in card reader.
Card reader
Trigger
Mode
Select if card events can be used as triggger conditions, deactivation with
the card reader becomes unavailable, and the reader cannot be
deactivated.
3. Configure the input.
WARNING: Your system will not comply with EN standards if you enable a function key to set the
system without a valid PIN being required.
Configuring a Keyswitch Expander
1. Select Settings > X-Bus > Expanders.
2. Click one of the keyswitch identifying parameters.
3. Configure the fields described in the tables below.
Description Enter a description for the keyswitch expander.
Key Options
Latch Select if key position should be latched.
Latch timer Enter duration of latch in seconds (0–9999, 0 means latch lasts until key
is turned the other way). Default is 0.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 163 I-200572
08.12.2023
To Next Page