Acre SPC42 - Page 164

Areas
Location Select the area where the keyswitch is located.
Visual Indications
Indicator/LED There is 1 indicator/LED on the right and 1 indicator/LED on the left side.
Function The function for this indicator/LED.
Function On Select the colour and the state for every indicator if the selected function
is ON.
Function Off Select the colour and the state for every indicator if the selected function
is OFF.
Change function Click this button to change the function for this indicator. The function can
be enabled or used for a system, area, zone or keyswitch.
Deactivation
Calendar Select if the keyswitch module should be limited by calendar.
Mapping gate Select if the keyswitch module should be limited by a mapping gate.
Output
Output x Configure and text the outputs for the keyswitch. See Editing an output
on page155 for more details.
Keyswitch Functions
Centre, Right and
Left Positions
Select the Function that that this keyswitch position will perform and the
relevant Area.
Keyswitch functions are:
l
None
l
Unset
l
Partset A
l
Partset B
l
Fullset
l
Toggle Unset / Fullset
l
Toggle Unset / Partset A
l
Toggle Unset / Partset B
l
All Okay
l
Setting authorisation
l
Shunt
WARNING: Your system will not comply with EN standards if you enable a keyswitch function to
set the system without a valid PIN being required.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 164 I-200572
08.12.2023