Acre SPC42 - Page 175

Restriction System Option Description
may come from the same device if the activations differ in type, that is,
alarm/tamper.
- 1 Alarm activation followed by an ATS[1] Fault within 30 minutes
(default).
- ATS fault followed by a tamper or alarm condition within 30 minutes
(default).
If the 30 minutes expires and the zone is restored to its normal physical
state, then the zone’s alerts will be restored if a level 2 user can restore
this alert. In this case, the zone will accept a new alert condition which
will cause a new activation.
Alternatively, if the zone has not been restored to its normal physical
state then that zone will be inhibited if that zone is allowed to be
inhibited.
If an alert (ATS) reoccurs after the 30 minute window (default), then the
30 minute timer will restart.
The EN50131-9 confirmation option is automatically set whenever the
Standards > Region option is set to Spain.
l
VDS
This will enforce compliance with the VDS standard.
Keypad
Always Show
State
(SHOW STATE)
If enabled, the setting status of the system (Fullset/Partset/Unset) is
permanently displayed in the bottom line of the keypad display. If unchecked
the setting status will disappear from the keypad display after 7 seconds.
Show Open
Zones
If enabled, open zones will display on keypad in Unset mode.
Call ARC
Message
If enabled, the ARC message will be displayed for 30 seconds after Unset, if
confirmed alarm has been reported.
Call ARC Line 1 ARC message in line 1 of display (16 chars).
Call ARC Line 2 ARC message in line 2 of display (16 chars).
Show Cameras If enabled, offline cameras will be displayed on the keypad in Unset mode.
Log Keypad
Access
Enable this option to log users' keypad access (successful and failed log-in
attempts).
Idle State
Language
Select the language displayed in idle state.
l
System Language: Language in which menus and texts on the keypads,
the web interface and the event log will be displayed.
l
Last Used: Last used language is displayed in idle state.
Use Simplified
Menu
Enable this option to use simplified set/unset menus on the 'Comfort' and
'Compact' Keypads (for one area configuration only).
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 175 I-200572
08.12.2023