Acre SPC42 - Page 176

Restriction System Option Description
PIN
PIN Digits Enter the number of digits for user PINs (max. 8 digits). Increasing the
number of digits will add the relevant number of zeros to the front of an
existing PIN, for example, an existing user PIN of 2134 (4 digits) will change
to 00002134 if the PIN digits is set to 8. If you decrease the number of PIN
digits, existing PINs will have their leading digits removed, for example, an
existing user PIN of 00002134 (8 digits) will change to 02134 if the PIN digits
is set to 5.
Note: This option cannot be changed if an SPC Manager PIN digit mode is
set. See SPC Manager on page244.
Note: To comply with INCERT approvals, the user’s PIN code must contain
more than 4 digits.
PACE and PIN If enabled, both PACE and PIN are required.
User Duress Select one of the following Duress options to activate this function on the
system.
l
PIN +1(system reserves the PIN before and after the user PIN for
duress.
l
PIN + 2 (system reserves two PINs before and after the user PIN for
duress.
Duress must be enabled for individual users. See section on Adding/Editing
a User.
PIN Policy Click the Edit button to select options for PIN usage.
l
Periodic changes required – enforces scheduled changes to the user’s
PIN. The period is defined in the PIN Valid field of Timers. See Timers
on page179.
l
Warn if changes required – generates a user alert if the user’s PIN is
about to expire, or has expired. The warning period is defined in the PIN
Warning field of Timers. See Timers on page179.
l
User selects the last digit – enables the user to select the last digit of
their pin. The preceding digits are automatically generated by the
system.
l
User selects the 2 digits - enables the user to select the last two digits of
their PIN. The preceding digits are automatically generated by the
system.
l
Limit Changes – limits the number of changes possible within a valid
PIN period. This value is defined in the PIN Changes Limit field of
Timers. See Timers on page179.
l
Secure PIN - If enabled the PIN will be automatically generated by the
panel.
Door & Reader
Reset Cards If enabled, access cards passback state will be reset every day at midnight.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 176 I-200572
08.12.2023