Restriction System Option Description
Web Only System General
Policy
Select options to manage remote control of the system and alarm and bell
settings from the following:
- No confirmed alarms if internally set
- Block remote restore
- Block remote isolates
- Block remote inhibits
- No external bell if internal set
- Delay reporting if entry active
- Confirmed alarm cancels delay
Web Only Confirmed
Alarms System
Alerts
Select which system alerts cause a confirmed alarms when at least one
alarm is active, and which system alerts cause the panel to enter the
tentative state.
Hold-up Data
Web Only Hold-up keyword
1
Enter the first hold-up keyword to send to the CMS in a Holdup Information
(HD) event.
Web Only Hold-up keyword
2
Enter the second hold-up keyword to send to the CMS in a Holdup
Information (HD) event.
Web Only Phone number 1 Enter the first site phone number to send to the CMS in a Holdup Information
(HD) event.
Web Only Phone number 2 Enter the second site phone number to send to the CMS in a Holdup
Information (HD) event.
*A WPA is compatible with SiWay RF Kit (SPCW120 or WRTX) only.
See also
Adding/Editing an area on page186
15.10.3.2 Timers
This page gives an overview about identified timer defaults and their description.
These settings, which vary depending on the defined Security Grade of the system, should only be
programmed by an authorised installation engineer. Changing settings could render the SPC
system noncompliant with security standards. Setting the Security Grade back to EN 50131 Grade
2 or EN 50131 Grade 3 overwrites any changes made on this page.
1. Select Configuration > System > System Timers.
The System Timers page displays.
2. Configure the fields as described in the following table.
Timers
Designation of the functions in the following order:
l
1st row: Web
l
2nd row: Keypad
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 179 I-200572
08.12.2023
To Next Page