Restriction System Option Description
SMS
SMS
Authentication
Select one of the following options:
l
PIN Code Only: This is a valid user code.
l
Caller ID Only: This is the phone number (including three-digit country
prefix code) as configured for user SMS control. SMS control will only be
available for configuration by the user when this option is selected.
l
PIN and Caller ID
l
SMS PIN Code Only This is a valid PIN code configured for the user
which is different from the user’s login code. SMS controls will only be
available for configuration by the user when this option is selected.
l
SMS PIN Code & Caller ID.
Policy
Web Only System Policy Configure engineer login and tamper reporting behavior for system.
Click Edit to configure general system behaviour.
You can set Advanced system operations, or configure the reporting settings
(Report on close, Restore on close, Limit reporting, and Log on close)
for the Alert options.
Web Only Timing Policy Display system timing policy.
Web Only Output
Configuration
Click the Edit button to configure latch and autoset output settings (see
Configuring system latch and auto set outputs on page159).
Web Only System Alert
Policy
This programming option allows you to restrict the user and engineer’s
ability to restore, Isolate and inhibit alerts. The manner in which the system
reacts to alerts can also be programmed.
Web Only Zone Alarm
Policy
Select whether particular zone alarms can be restored, inhibited or isolated
by the user and engineer.
Web Only Zone Tamper
Policy
Select whether particular zone tampers can be restored, inhibited or isolated
by the user and engineer.
Web Only Keypad Display
Policy
Select events to be displayed on keypads in both Set and Unset modes.
Web Only Keypad LED
Policy
Select which LEDs will be displayed on keypads in both Set and Unset
modes.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 178 I-200572
08.12.2023
To Next Page