l
Default Event Profile
l
Default Command Profile (this does not support audio video verification)
l
Default FlexC Command User Name (FlexC) and Command Password (FlexC) for controlling
the panel from the RCT (for example, SPC Com XT)
l
Auto Encryption with no password
1. To quickly configure a FlexC connection between a panel and an RCT (for example, SPC Com
XT), go to Communications > FlexC > FlexC ATS.
2. Under Add EN50136-1 ATS, choose one of the following to display the ATP Configuration :
l
Add Single Path ATS - primary ATP only
l
Add Dual Path ATS - primary and backup ATPs
l
Add Dual Path Dual Server ATS - primary and backup ATPs, primary and backup servers
3. Complete the fields on the ATP Configuration - EN50136 ATS page as shown in the table
below. At a minimum, you must complete the field RCT URL or IP Address to save. If you do not
enter an SPT Account Code, you can commission the panel using the ATS Registration ID
which is automatically generated when you save. The RCT operator must enter this ATS
Registration ID, for example, in SPC Com XT.
4. Click Save. The ATS Configuration page displays showing the ATS Registration ID and the
configured primary ATP or primary and backup ATPs in the Event Sequence Table.
5. On the ATS Configuration page, click Save to accept the default settings, for example, the
Default Event Profile, the Default Command Profile (including the FlexC Command User
Name and FlexC Command Password), and Auto Encryption with no password. To change
the settings, see Configuring an EN50136-1 ATS or Custom ATS on the facing page.
6. Click Back. The ATS displays in the Configured ATS table.
Panel Identification
ATS Name Enter the name of the ATS. If you do not enter a value, the ATS name defaults to ATS 1, ATS 2,
etc.
SPT
Account
Code
The number that uniquely identifies the panel to the RCT. Enter 0 if you do not have the SPT
Account Code. In this case, you can commission the panel using the ATS Registration ID. For an
EN50136 ATS, the ATS Registration ID is automatically generated when you click Save. The
RCT can send the SPT Account Code to the panel when it is available.
RCT Identification & Backup RCT Identification (Dual Path Dual Server Only)
RCT ID Enter the RCT ID that uniquely identifies the RCT (for example, SPC Com XT) to the panel. This
must match the value entered in the SPC Com XT Server Configuration Manager tool in the
Server RCT ID field in the Server Details tab. See the SPC Com XT Installation & Configuration
Manual.
RCT URL
or IP
Address
Enter the RCT URL or IP Address for the RCT server location (for example, SPC Com XT server).
RCT TCP
Port
Enter the TCP port for the RCT (for example, SPC Com XT). This must be the same value entered
for the field Server FlexC Port in the SPC Com XT Server Configuration Manager tool.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 217 I-200572
08.12.2023
To Next Page