Acre SPC42 - Page 229

Event
Timeout
The amount of time that the ATP will keep trying to transmit the event until
the event fails on the ATP and is passed to the next ATP.
l
30 seconds
l
60 seconds
l
90 seconds
l
2 minutes
l
3 minutes
l
5 minutes
l
10 minutes
Minimum Message Lengths
Poll Message Minimum length of a poll message.
l
0 Bytes
l
64 Bytes
l
128 Bytes
l
256 Bytes
l
512 Bytes
Event
Message
Minimum length of an event and test call message.
l
0 Bytes
l
64 Bytes
l
128 Bytes
l
256 Bytes
l
512 Bytes
Other
Message
Minimum length of connection and encryption key and update messages.
l
0 Bytes
l
64 Bytes
l
128 Bytes
l
256 Bytes
l
512 Bytes
2. Click Save.
Add ATP to Analog ARC
If a connection between the SPC panel and RCT (for example, SPC Com XT) goes down, FlexC has the
ability to switch to a backup ATP connection between the SPC panel and an Analog ARC. You can
configure up to 10 ATPs for each ATS.
1. To configure an ATP between an SPC panel and an Analog ARC, click the button Add ATP to
Analog ARC.
2. Complete the ATP fields described in the table below.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 229 I-200572
08.12.2023