Acre SPC42 - Page 240

Live
Streaming/Streaming
Mode
Specifies when live streaming of audio and video is available.
Options are Never, Always or Only after an alarm event. Default is
‘Only after an alarm event’.
Note: This setting has obvious privacy implications and therefore
should be enabled only where appropriate and subject to local laws
and regulations.
Network (Applies to the Ethernet connection only)
Network Enable Check this box to allow events to be reported through the network.
Network Protocol Select the type of network protocol for the receiver. Options are
UDP and TCP. TCP is recommended if supported by the receiver.
Receiver ID Address Enter the IP address of the receiver.
Receiver IP Port Enter the IP port that the EDP receiver is listening on.
Always Connected If enabled the panel will keep a permanent connection to the
receiver. If disabled, the panel will only connect to the receiver after
an alarm event.
Panel Master If enabled the panel is master of polling messages. Only applicable
to UDP connections.
Polling Interval Enter the number of seconds between polls.
Polling Trigger Enter the number of missing polls before a network connection fail
is registered. Only applicable to UDP connections.
Generate a Network
Fault
If polling fails, a network fault alert is generated.
Dial-up (Applies to the GPRS modem connection only)
Dial-up Enable Check this box to report events through a dial-up connection.
Call type Select type of call to use when dial up is enabled. Select GPRS.
GPRS protocol Select the transport layer protocol used over the GPRS
connection. Options are UDP or TCP. Only applicable if Call Type
is GPRS.
GPRS address Enter the IP address of EDP receiver for GPRS connections. Only
applicable if Call Type is GPRS.
GPRS port Enter the port that the EDP receiver is listening on for GPRS
connections Options are UDP or TCP. Only applicable if Call Type
is GPRS. Default is 50000.
GPRS Hangup
Timeout
Enter the time in seconds after which the GPRS call will hang up.
(0=stayconnected until IP connection is up)
GPRS Autoconnect Check this box to automatically trigger a GPRS call to the server if
an IP network fault occurs.
Dial-up on Net Fault Check this box to report network faults on a dial-up test call.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 240 I-200572
08.12.2023