Acre SPC42 - Page 241

To Next Page

To Previous Page

Dial-up Interval 1* Enter the number of minutes between dial-up test calls when

network link is up.

Dial-up Interval 2* Enter number of minutes between dial-up test calls when network

link is down.

Network Address* Enter the IP address of the receiver. This is only required if the

connection to the EDP receiver is being made over the Ethernet

interface. If using one of the on-board modems then leave this field

blank.

Phone Number* Enter the first phone number that the modem(s) will dial to contact

the receiver.

Phone Number 2* Enter a second phone number that the modem(s) will dial in the

event that the first number dialled did not result in a call being

successfully established.

Events

Primary Receiver Check this box to indicate that this is the primary receiver. If

unchecked, this is a backup receiver.

Re-queue Events Check this box if events that failed to report are to be re-queued for

transmission

Verification Check this box if Audio/Video verification is to be sent to this

receiver.

Event Filter Click this button to edit the filter events that will trigger an EDP call.

See Editing Event Filter Settings below.

* EDP dial-up over PSTN is not supported in this release.