3. See table below for further information.
Description Enter a text description of the receiver.
Receiver ID Enter a unique number which will be used by the EDP to identify the receiver.
See also
Editing EDP Receiver Settings below
Editing EDP Receiver Settings
1. Select Communications > Reporting > EDP > Edit.
2. Configure the fields as described in the table below.
Description Edit the name of the EDP receiver. Maximum 16 characters.
Receiver ID Edit the EDP receiver ID. Range is 1 to 999997 (999998 and
999999 are reserved for special purposes)
Protocol Version Select the EDP protocol version to use with this EDP receiver.
Options are Version 1 or Version 2. Version 2 is recommended if
supported by the receiver, as it is a more secure protocol.
VdS 2471 Compatible (Vds standard only)
If this option is selected then the EDP receiver will enforce the
following settings for that receiver:
l
8s polling interval
l
TCP protocol enforced
l
TCP retries will fail before 10s (9s approx)
l
EDP event retries are set to 1 independent of the global “Retry
Count” setting in “EDP Settings”
l
FTC will be generated within 20s of network failure.
Security
Commands Enable Check this box to allow commands to be accepted from the
receiver.
Change User PINs Check this box to allow user PINs to be changed from a remote
location. This feature is applicable only if commands are enabled
from the receiver.
Encryption Enable Check this box to enable encryption on data to and from the
receiver.
Encryption Key Enter a hexadecimal key (max. 32 digits) that will be used to
encrypt the data.
Note: The same key will need to be used at the receiver.
Virtual Keypad Enables access to the panel with a virtual keypad, that is, a PC
software module that looks and behaves like an SPC keypad. It is
available with the SPC Com client.
SPC42/52/53/63 – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2023 239 I-200572
08.12.2023
To Next Page